The holy grail of layerheight .1mm

With my new and improved setup I dared testing how .1mm layer height would look like.

Results are mixed, for some reason the model rips itself apart. I also get the feeling that I'm hitting the lower extrusion speed limit if something like it exists.

First I tried normal speeds (30-40mm/s) with otherwise normal settings and furthermore reducing the retraction to 1mm @ 40mm/s.

Then I tried to increase the output by raising the the layer width to 300%, that looked better.

Pushing this even higher to 400% width and 0 retraction made it almost perfect. This is a simple test piece and I haven't managed a complexer piece yet.